301b

301b practice questions, page 3 of 9, with answer review and explanations.

Question 11

What is the correct command to reset an LTM device to its default settings?

  1. tmsh reset-all default
  2. tmsh set /sys config defaults
  3. tmsh load /sys config default
  4. tmsh /util bigpipe reset-factory-defaults

Question 12

In which file would the LTM Specialist find virtual server configurations?

  1. bigip.conf
  2. bigip_sys.conf
  3. bigip_base.conf
  4. profile_base.conf

Question 13

When re-licensing an LTM device from the command line interface, which tmsh command should the LTM Specialist use to generate the required information to provide on the F5 licensing portal?

  1. tmsh run /util get-dossier
  2. tmsh generate /sys dossier
  3. tmsh list /sys registration-key
  4. tmsh install /sys license registration-key

Question 14

A device on the network is configured with the same IP address as the management address of the active LTM device, causing the management GUI to be inaccessible. Which two methods should the LTM Specialist use to access the LTM device in order to change the management IP address? (Choose two.)

  1. Connect via ssh to the AOM IP address.
  2. Connect via ssh to the management address.
  3. Connect to the LTM device via serial connection.
  4. Connect a monitor and keyboard to the LTM device.
  5. Connect via ssh to the standby unit and connect via ssh across the serial link between the devices.

Question 15

The LTM Specialist is in the process of creating a USB boot drive for the purpose of restoring the BIG-IP software to an LTM device. A separate LTM device has been selected for the purpose of creating the USB boot drive. The BIG-IP software ISO has already been uploaded and mounted on the separate LTM device. Which command should the LTM Specialist use to trigger the LTM device to install the BIG-IP software to the USB boot drive?

  1. tmsh
  2. install
  3. mkdisk
  4. bigip_software_create