300-815 Practice Test

300-815 Practice Test practice questions, page 7 of 10, with answer review and explanations.

Question 31

After configuring a Cisco CallManager Express with Cisco Unity Express, inbound calls from the PSTN SIP trunk receive a ring tone for 20 seconds and then a busy signal instead of voicemail. Which configuration fixes this problem?

  1. Router(config)# voice service voip Router(conf-voi-serv)#allow-connections h323 to h323
  2. Router(config)#dial-peer voice 2 voip Router(config-dial-peer)#no vad
  3. Router(config)# voice service voip Router(conf-voi-serv)#allow-connections voice-mail mod
  4. Router(config)# voice service voip Router(conf-voi-serv)#no supplementary-service sip moved-temporarily

Question 32

An engineer must configure a secure SIP trunk with a remote provider, with a specific requirement to use port 5065 for inbound and otubound traffic. Which two items must be configured to complete this configuration? (Choose two.)

  1. Incoming Port in SIP Information section of the SIP Trunk configuration.
  2. Incoming Port in Security Information of the SIP Profile configuration.
  3. Destination Port in SIP Information section of the SIP Trunk configuration
  4. Incoming Port in SIP Trunk Security Profile configuration
  5. Destination Port in SIP Trunk Security Profile configuration

Question 33

In Cisco Unified Communications Manager, which tool do you use to check SIP traces?

  1. MTP
  2. CCSIP
  3. RTMT
  4. OS Administration Page

Question 34

If all patterns below are configured in Cisco Unified Communications Manager which would be used when dialing the pattern "123"?

  1. 12!
  2. 12X (urgent priority set)
  3. 1XX (urgent Priority Set)
  4. 12[2-5]

Question 35

Which configuration must an administrator perform to display Translation Pattern operations in Cisco Unified Communications Manager SDL traces?

  1. Enable the Detailed Call Analysis option under Enterprise Parameters for Unified CM.
  2. Set up the Digit Analysis Complexity in Service Parameters for Cisco Unified CM to TranslationAndAlternatePatternAnalysis.
  3. Check the Translation Patterns Analysis check box in Micro Traces on the Cisco Unified CM Serviceability page.
  4. By default, the Translation Patterns operations are printed in SDL traces, so no additional configuration is necessary.