300-815 Practice Test

300-815 Practice Test practice questions, page 4 of 10, with answer review and explanations.

Question 16

Which action is correct with respect to toll fraud prevention configuration in the Cisco Unified Communications Manager Express?

  1. Configure Direct Inward Dial for Incoming ISDN Calls with overlap dialing.
  2. Configure IP Address Trusted Authentication for Incoming VoIP Calls.
  3. Configure the command no ip address trusted authenticate under "voice service voip".
  4. Enable Secondary Dial tone on Analog and Digital FXO Ports.

Question 17

You see the voice register pool 1 command in your Cisco Unified Communications Manager Express configuration. Which configuration is occurring in this section?

  1. configuration for a single SIP phone
  2. configuration items common for all SIP phones
  3. configuration for a pool of SIP phones (similar to device pool on Cisco Unified Communications Manager)
  4. configuration for SIP registrar service

Question 18

Which top-level IOS command is needed to begin the configuration of a Cisco Unified Communications Manager Express gateway to enable phones to be registered via SIP?

  1. allow-connections sip to sip
  2. voice service voip
  3. voice register global
  4. voice register dn

Question 19

For s SIP to SIP call flow, when does Cisco Unified Border Element require transcoding resources for DTMF?

  1. interworking between an OOB method and RFC2833 for flow-around calls
  2. interworking between h245-signal and rtp-nte
  3. interworking between an OOB method and RFC2833 for flow-through calls
  4. interworking between h245-alpha numeric and sip-kpml

Question 20

Where is the dtmf-relay command configured on Cisco Unified Border Element?

  1. in the voice-class VoIP configuration
  2. in the VoIP dial peer
  3. in global SIP configuration
  4. in the VoIP or POTS dial peers