300-615

300-615 practice questions, page 5 of 11, with answer review and explanations.

Question 21

An attempt to use a global vNIC redundancy template pair results in a service profile that fails to apply. Which action resolves the issues?

  1. Create the peer names before creating the templates.
  2. Assign the secondary template first, and then set the peer name.
  3. Assign both templates simultaneously.
  4. Assign the primary template first, and then set the peer name.

Question 22

An engineer attempts to register Cisco UCS Manager to Cisco UCS Central, but the registration fails. The engineer can ping Cisco UCS Central from UCS Manager. Which two actions must the engineer attempt to resolve the problem? (Choose two.)

  1. Synchronize the date and time to NTP for Cisco UCS Central and the Cisco UCS domains.
  2. Apply the UCS Central license to UCS Central.
  3. Place Cisco UCS Manager on the same subnet as Cisco UCS Central.
  4. Allow port 443 between Cisco UCS Manager and Cisco UCS Central.
  5. Allow port 9443 between Cisco UCS Manager and Cisco UCS Central.

Question 23

A Cisco ACI environment consists of three Cisco APICs, two spine switches, and four leaf switches. The engineer erases and reboots all APICs first, then leaf and spine switches individually, and then completes the Initial Setup dialog on the APIC1 CIMC KVM console. When the engineer logs in to the APIC1 web GUI, the engineer notices that there are no directly connected leaf switches being discovered under Fabric > Inventory > Fabric Membership. What is the cause of the issue?

  1. The leaf nodes were not erased properly, which caused a fabric parameters mismatch with the APIC1.
  2. Rebooting the APICs and the leaf and spine switches after wiping them is not required.
  3. The engineer did not enter the TEP Pool value during the Initial Setup dialog on APIC1.
  4. The same Fabric Name value should be used before and after wiping all devices.

Question 24

Drag and drop the Cisco UCS SNMP fault types from the left onto the correct issues on the right. Select and Place:

Question 25

An engineer must replace a failed memory on a Cisco UCS B-Series Blade Server. After the replacement was done, the server has a "resolve slot" warning. Which server maintenance action resolves the issue?

  1. Perform diagnostic interrupt on the server.
  2. Re-acknowlegement the server.
  3. Reset the server.
  4. Decomission the server.