300-515: Implementing Cisco Service Provider VPN Services (SPVI)
300-515: Implementing Cisco Service Provider VPN Services (SPVI) practice questions, page 6 of 6, with answer review and explanations.
Question 26
Which two are characteristics of using a non-MPLS peer-to-peer model over a traditional overlay model? (Choose two.)
The model is suited for nonredundant configurations.
The configuration on a newly added site PE is updated automatically.
Provider routers know the customer network topology.
The customer specifies the exact site-to-site traffic profile.
Routing information is exchanged between the customer router and one or a few PEs.
Question 27
While troubleshooting EoMPLS configuration problems, which three parameters should an engineer match between the two ends of the pseudowire configurations? (Choose three.)
VLAN name
Xconnect group name
EFP subinterface number
pseudowire ID
MTU size
control word usage
Question 28
What do EVPN single-active and all-active have in common?
They are default gateway redundancy options.
They are multihoming mechanisms used for CE devices.
They are used to provide single connection from a CE device to a service provider.
They are both roles that a designated router can take when MPLS is used with EVPN.
Question 29
Refer to the exhibit. Which result occurs when PE1 learns a new MAC address and all three PEs are enabled with EVPN native?
A system notification is sent to the network administrator that triggers the manual configuration of the new MAC address on PE2 and PE3.
The new MAC address is sent by BGP to PE2 and PE3 as a Type 2 BGP route.
The MAC address is entered into the CAM table and is classified for use on the native VLAN
The MAC address is entered into the CAM table only if it is learned on the native VLAN.