300-415 Practice Test

300-415 Practice Test practice questions, page 9 of 20, with answer review and explanations.

Question 41

An engineer is troubleshooting a certificate issue on vEdge. Which command is used to verify the validity of the certificates?

  1. show control local-properties
  2. show control summary
  3. show certificate installed
  4. show certificate status

Question 42

Refer to the exhibit. An engineer is troubleshooting a control connection issue. What does `connect` mean in this show control connections output?

  1. Control connection is down
  2. Control connection is up
  3. Control connection attempt is in progress
  4. Control connection is connected

Question 43

In which device state does the WAN Edge router create control connections, but data tunnels are not created?

  1. valid
  2. backup
  3. active
  4. staging

Question 44

What is the purpose of `vpn 0` in the configuration template when onboarding a WAN Edge node?

  1. It carries control traffic over secure IPsec connections between vSmart controllers and vEdge routers, and between vEdge and vManager.
  2. It carries control traffic over secure IPsec connections between vSmart controllers and vEdge routers, and between vSmart and vBond.
  3. It carries control traffic over secure DTLS or TLS connections between vSmart controllers and vEdge routers, and between vSmart and vBond.
  4. It carries out-of-band network management traffic among the Cisco SD-WAN devices in the overlay network.

Question 45

A policy is created to influence routing path in the network using a group of prefixes. Which policy application will achieve this goal when applied to a site list?

  1. control-policy
  2. vpn-membership policy
  3. app-route policy
  4. cflowd-template