300-415 Practice Test

300-415 Practice Test practice questions, page 18 of 20, with answer review and explanations.

Question 86

Refer to the exhibit. Which configuration value is used to change the administrative distance of iBGP routes to 20?

  1. Configure Internal Routes Distance to 20.
  2. Configure Propagate AS Path to off.
  3. Configure Local Routes Distance to 20.
  4. Configure External Routes Distance to 20.

Question 87

How is multicast routing enabled on devices in the Cisco SD-WAN overlay network?

  1. The WAN Edge routers originate multicast service routes to the vSmart controller via OMP, which then forwards joins for requested multicast groups based on IGMP v2 or v3 toward the source or PIM-RP as specified in the original PIM join message.
  2. The WAN Edge routers originate multicast service routes to the vSmart controller via OMP, which then forwards joins for requested multicast groups based on IGMP v1 or v2 toward the source or PIM-RP as specified in the original PIM join message.
  3. The vSmart controller originates multicast service routes to the WAN Edge routers via OMP, which then forwards joins for requested multicast groups based on IGMP v1 or v2 toward the source or PIM-RP as specified in the original PIM join message.
  4. The vSmart controller originates multicast service routes to the WAN Edge routers via OMP, which then forwards joins for requested multicast groups based on IGMP v2 or v3 toward the source or PIM-RP as specified in the original PIM join message.

Question 88

Refer to the exhibit. The network team must configure branch B WAN Edge device 103 to establish dynamic full-mesh IPsec tunnels between all colors with branches over MPLS and Internet circuits. The branch is configured with: Which configuration meets the requirements? A. B. C. D.

Question 89

Refer to the exhibit. The engineering must assign community tags to 3 of its 74 critical server networks as soon as they are advertised to BGP peers. These server networks must not be advertised outside AS. Which configuration fulfills this requirement? A. B. C. D.

Question 90

WAN Edge routers are configured manually to use UDP port offset to use nondefault offset values when IPsec tunnels are created. What is the offset range?

  1. 1-19
  2. 0-18
  3. 0-19
  4. 1-18