300-410 Practice Test practice questions, page 9 of 25, with answer review and explanations.
Question 41
Refer to the exhibit. Routing protocols are mutually redistributed on R3 and R1. Users report intermittent connectivity to services hosted on the 10.1.1.0/24 prefix. Significant routing update changes are noticed on R3 when the show ip route profile command is run. How must the services be stabilized?
The routing loop must be fixed by reducing the admin distance of OSPF from 110 to 80 on R3
The routing loop must be fixed by reducing the admin distance of iBGP from 200 to 100 on R3
The issue with using BGP must be resolved by using another protocol and redistributing it into EIGRP on R3
The issue with using iBGP must be fixed by running eBGP between R3 and R4
Question 42
When determining if a system is capable of support, what is the minimum time spacing required for a BFD control packet to receive once a control packet is arrived?
Desired Min TX Interval
Detect Mult
Required Min RX Interval
Required Min Echo RX Interval
Question 43
An engineer is configuring a network and needs packets to be forwarded to an interface for any destination address that is not in the routing table. What should be configured to accomplish this task?
set ip next-hop
set ip default next-hop
set ip next-hop recursive
set ip next-hop verify-availability
Question 44
What is an advantage of using BFD?
It detects local link failure at layer 1 and updates the routing table.
It detects local link failure at layer 3 and updates the routing protocols.
It has sub-second failure detection for layer 1 and layer 3 problems.
It has sub-second failure detection for layer 1 and layer 2 problems.
Question 45
An engineer needs dynamic routing between two routers and is unable to establish OSPF adjacency. The output of the show ip ospf neighbor command shows that the neighbor state is EXSTART/EXCHANGE. Which action should be taken to resolve this issue?