300-410 Practice Test

300-410 Practice Test practice questions, page 5 of 25, with answer review and explanations.

Question 21

Refer to the exhibit. An IP SLA was configured on router R1 that allows the default route to be modified in the event that Fa0/0 loses reachability with the router R3 Fa0/0 interface. The route has changed to flow through router R2. Which debug command is used to troubleshoot this issue?

  1. debug ip flow
  2. debug ip sla error
  3. debug ip routing
  4. debug ip packet

Question 22

Which configuration enables the VRF that is labeled `Inet` on FastEthernet0/0?

  1. R1(config)# ip vrf Inet R1(config-vrf)#ip vrf FastEthernet0/0
  2. R1(config)#ip vrf Inet FastEthernet0/0
  3. R1(config)# ip vrf Inet R1(config-vrf)#interface FastEthernet0/0 R1(config-if)#ip vrf forwarding Inet
  4. R1(config)#router ospf 1 vrf Inet R1(config-router)#ip vrf forwarding FastEthernet0/0

Question 23

Refer to the exhibit. After redistribution is enabled between the routing protocols; PC2, PC3, and PC4 cannot reach PC1. Which action can the engineer take to solve the issue so that all the PCs are reachable?

  1. Set the administrative distance 100 under the RIP process on R2.
  2. Filter the prefix 10.1.1.0/24 when redistributed from OSPF to EIGRP.
  3. Filter the prefix 10.1.1.0/24 when redistributed from RIP to EIGRP.
  4. Redistribute the directly connected interfaces on R2.

Question 24

Refer to the exhibit. A router is receiving BGP routing updates from multiple neighbors for routes in AS 690. What is the reason that the router still sends traffic that is destined to AS 690 to a neighbor other than 10.222.1.1?

  1. The local preference value in another neighbor statement is higher than 250.
  2. The local preference value should be set to the same value as the weight in the route map.
  3. The route map is applied in the wrong direction.
  4. The weight value in another neighbor statement is higher than 200.

Question 25

Refer to the exhibit. R1 and R2 cannot establish an EIGRP adjacency. Which action establishes EIGRP adjacency?

  1. Remove the current autonomous system number on one of the routers and change to a different value.
  2. Add the passive-interface command to the R1 configuration so that it matches the R2 configuration.
  3. Remove the passive-interface command from the R2 configuration so that it matches the R1 configuration.
  4. Add the no auto-summary command to the R2 configuration so that it matches the R1 configuration.