200-301 Practice Test practice questions, page 40 of 56, with answer review and explanations.
Question 196
Two switches are connected and using Cisco Dynamic Trunking Protocol. SW1 is set to Dynamic Auto and SW2 is set to Dynamic Desirable. What is the result of this configuration?
The link becomes an access port.
The link is in an error disabled state.
The link is in a down state.
The link becomes a trunk port.
Question 197
A Cisco IP phone receives untagged data traffic from an attached PC. Which action is taken by the phone?
It drops the traffic.
It allows the traffic to pass through unchanged.
It tags the traffic with the native VLAN.
It tags the traffic with the default VLAN.
Question 198
Which design element is a best practice when deploying an 802.11b wireless infrastructure?
allocating nonoverlapping channels to access points that are in close physical proximity to one another
disabling TCP so that access points can negotiate signal levels with their attached wireless devices
configuring access points to provide clients with a maximum of 5 Mbps
setting the maximum data rate to 54 Mbps on the Cisco Wireless LAN Controller
Question 199
Refer to the exhibit. The network administrator wants VLAN 67 traffic to be untagged between Switch 1 and Switch 2, while all other VLANs are to remain tagged. Which command accomplishes this task?
switchport access vlan 67
switchport trunk allowed vlan 67
switchport private-vlan association host 67
switchport trunk native vlan 67
Question 200
Which two command sequences must be configured on a switch to establish a Layer 3 EtherChannel with an open-standard protocol? (Choose two.)
interface GigabitEthernet0/0/1 channel-group 10 mode auto
interface GigabitEthernet0/0/1 channel-group 10 mode on
interface port-channel 10 no switchport ip address 172.16.0.1 255.255.255.0
interface GigabitEthernet0/0/1 channel-group 10 mode active