200-301 Practice Test

200-301 Practice Test practice questions, page 32 of 56, with answer review and explanations.

Question 156

Refer to the exhibit. An IP subnet must be configured on each router that provides enough addresses for the number of assigned hosts and anticipates no more than 10% growth for new hosts. Which configuration script must be used? A. B. C. D.

Question 157

Which action is taken by a switch port enabled for PoE power classification override?

  1. As power usage on a PoE switch port is checked data flow to the connected device is temporarily paused
  2. When a powered device begins drawing power from a PoE switch port, a syslog message is generated
  3. If a switch determines that a device is using less than the minimum configured power, it assumes the device has failed and disconnects it
  4. Should a monitored port exceed the maximum administrative value for power, the port is shut down and err-disabled

Question 158

What is a function spine-and-leaf architecture?

  1. Offers predictable latency of the traffic path between end devices.
  2. Exclusively sends multicast traffic between servers that are directly connected to the spine.
  3. Mitigates oversubscription by adding a layer of leaf switches.
  4. Limits payload size of traffic within the leaf layer.

Question 159

Which action is taken by the data plane within a network device?

  1. Constructs a routing table based on a routing protocol.
  2. Forwards traffic to the next hop.
  3. Looks up an egress interface in the forwarding information base.
  4. Provides CLI access to the network device.

Question 160

What is the function of the control plane?

  1. It exchanges routing table information.
  2. It provides CLI access to the network device.
  3. It looks up an egress interface in the forwarding information base.
  4. It forwards traffic to the next hop.