200-301 Practice Test

200-301 Practice Test practice questions, page 29 of 56, with answer review and explanations.

Question 141

Drag and drop the characteristics of transport layer protocols from the left onto the corresponding protocols on the right. Select and Place:

Question 142

A network engineer must configure an interface with IP address 10.10.10.145 and a subnet mask equivalent to 11111111.11111111.11111111.11111000. Which subnet mask must the engineer use?

  1. /29
  2. /30
  3. /27
  4. /28

Question 143

Refer to the exhibit. The switches are connected via a Cat5 Ethernet cable that is tested successfully. The interfaces are configured as access ports and are both in a down status. What is the cause of the issue?

  1. The speed settings on the switches are mismatched
  2. The distance between the two switches is not supported by Cat5
  3. The switches are configured with incompatible duplex settings
  4. The portfast command is missing from the configuration

Question 144

Which two IP addressing schemes provide internet access to users on the network while preserving the public IPv4 address space? (Choose two.)

  1. IPv6 addressing
  2. PAT with private internal addressing
  3. single public Class A network
  4. private networks only
  5. custom addresses from ARIN

Question 145

The address block 192.168.32.0/24 must be subnetted into smaller networks. The engineer must meet these requirements: ✑ Create 8 new subnets. ✑ Each subnet must accommodate 30 hosts. ✑ Interface VLAN 10 must use the last usable IP in the first new subnet. ✑ A Layer 3 interface is used. Which configuration must be applied to the interface?

  1. no switchport mode trunk ip address 192.168.32.97 255.255.255.224
  2. switchport ip address 192.168.32.65 255.255.255.240
  3. no switchport ip address 192.168.32.30 255.255.255.224
  4. no switchport mode access ip address 192.168.32.62 255.255.255.240