1z0-821

1z0-821 practice questions, page 9 of 10, with answer review and explanations.

Question 41

You start to execute a program by using the following command: ~/bigscript & You then determine that the process is not behaving as expected, and decide that you need to terminate the process. Based on the information shown below, what is the process number you should terminate?

  1. 15163
  2. 15156
  3. 15166
  4. 15165

Question 42

You have installed the SMF notification framework to monitor services. Which command is used to set up the notifications for a particular service?

  1. svccfg
  2. svcadm
  3. setnotify
  4. smtp-notify

Question 43

User jack logs in to host Solaris and executes the following command sequence: Which three statements are correct?

  1. User jack can edit testfile because he has read and write permissions at the group level.
  2. User jack can use cat to output the contents of testfile because he has read permission as the file owner.
  3. User jill can change the permissions of testfile because she has write permission for the file at the group level.
  4. User jill can edit testfile because she has read and write permission at the group level.
  5. User jack can change permissions for testfile because he is the owner of the file.
  6. User jack can change permissions for testfile because he has execute permission for the file.

Question 44

The OpenBoot firmware controls the operation of the system before the operating system is loaded. Which four tasks are directly controlled by the OpenBoot firmware?

  1. Provides a list of boot entries from which to choose
  2. Allows hardware to identify itself and load its own plug-in device driver
  3. Loads the boot loader from the configured boot device
  4. Performs basic hardware testing
  5. Installs the console
  6. Reads and executes the boot archive
  7. Extract and executes the kernel image

Question 45

Which two options are accurate regarding the non-global zone console?

  1. Access the non-global zone console by using the zlogin –c command.
  2. Access the non-global zone console by using the zlogin –1 command.
  3. Disconnect from the non-global zone console by using the ~. keys.
  4. Disconnect from the non-global zone console by using the #. keys.