1z0-821 practice questions, page 4 of 10, with answer review and explanations.
Question 16
When speaking to an Oracle Support Engineer, you are asked to verify the version of the Solaris 11 build currently running on your system. Which command would display the Solaris 11 build version currently running on your system?
pkg info all
cat /etc/release
cat /etc/update
prtconf | grep –i update
pkg info entire
Question 17
You need to configure an ISCSI target device on your x86 based Oracle Solaris II system. While configuring the iSCSI device, the following error is displayed: bash: stmfadm: command not found Which option describes the solution to the problem?
The COMSTAR feature is not supported on the x86 platform. The feature is supported only on the SPARC platform.
Use the iscsitadm command on the x86 platform when configuring an iSCSI target.
Install the storage-server group package on this system.
Start the iSCSI target daemon on this system.
Question 18
Your SPARC server will not boot into multi user-server milestones and you need to troubleshoot to out why. You need to start the server with minimal services running so that you can go through each milestone manually to troubleshoot the issue. Select the option that boots the server with the fewest services running.
boot -s
boot milestone none
boot -m milestone=single-user
boot -m milestone=none
boot -m none
Question 19
User1 is attempting to assist user2 with terminating user2's process 1234. User1 entered the following: kill -9 1234 Why does the process continue to run?
You can kill a process only if you are root.
You can kill only a process that you own.
You can kill the process only with the pkill command.
You need to kill the process with a stronger kill signal.
Question 20
Your server has one zone named dbzone (hat has been configured, but not yet installed). Which command would you use to view all the options that were used to configure this zone?