156-915.77

156-915.77 practice questions, page 33 of 34, with answer review and explanations.

Question 161

When Load Sharing Multicast mode is defined in a Cluster XL cluster object, how are packets being handled by cluster members?

  1. All members receive all packets. The Security Management Server decides which member will process the packets. Other members delete the packets from memory.
  2. All cluster members process all packets and members synchronize with each other.
  3. All members receive all packets. All members run an algorithm which determines which member processes packets further and which members delete the packet from memory.
  4. Only one member at a time is active. The active cluster member processes all packets.

Question 162

Which of the following does NOT happen when using Pivot Mode in Cluster XL?

  1. The Security Gateway analyzes the packet and forwards it to the Pivot.
  2. The packet is forwarded through the same physical interface from which it originally came, not on the sync interface.
  3. The Pivot's Load Sharing decision function decides which cluster member should handle the packet.
  4. The Pivot forwards the packet to the appropriate cluster member.

Question 163

When distributing IPSec packets to gateways in a Load Sharing Multicast mode cluster, which valid Load Sharing method will consider VPN information?

  1. Load Sharing based on IP addresses, ports, and serial peripheral interfaces
  2. Load Sharing based on SPIs
  3. Load Sharing based on ports, VTI, and IP addresses
  4. Load Sharing based on IP addresses, ports, and security parameter indexes

Question 164

By default, the Cluster Control Protocol (CCP) uses this to send delta sync messages to other cluster members.

  1. Broadcast
  2. Unicast
  3. Multicast
  4. Shout cast

Question 165

To configure the Cluster Control Protocol (CCP) to use Broadcast, the following command is run:

  1. set_ccp cpcluster broadcast
  2. ccp broadcast
  3. clusterconfig set_ccp broadcast
  4. cphaconf set_ccp broadcast