156-215.77

156-215.77 practice questions, page 4 of 15, with answer review and explanations.

Question 16

Which utility allows you to configure the DHCP service on GAiA from the command line?

  1. ifconfig
  2. sysconfig
  3. cpconfig
  4. dhcp_cfg

Question 17

The third-shift Administrator was updating Security Management Server access settings in Global Properties and testing. He managed to lock himself out of his account. How can you unlock this account?

  1. Type fwm unlock_admin from the Security Management Server command line.
  2. Type fwm unlock_admin -u from the Security Gateway command line.
  3. Type fwm lock_admin -u <account name> from the Security Management Server command line.
  4. Delete the file admin.lock in the Security Management Server directory $FWDIR/tmp/.

Question 18

The third-shift Administrator was updating Security Management Server access settings in Global Properties. He managed to lock all administrators out of their accounts. How should you unlock these accounts?

  1. Delete the file admin.lock in the Security Management Server directory $FWDIR/tmp/.
  2. Reinstall the Security Management Server and restore using upgrade_import.
  3. Type fwm lock_admin -ua from the Security Management Server command line.
  4. Login to SmartDashboard as the special cpconfig_admin user account; right-click on each administrator object and select unlock.

Question 19

You are the Security Administrator for ABC-Corp. A Check Point Firewall is installed and in use on GAiA. You are concerned that the system might not be retaining your entries for the interfaces and routing configuration. You would like to verify your entries in the corresponding file(s) on GAiA. Where can you view them? Give the BEST answer.

  1. /etc/sysconfig/netconf.C
  2. /etc/conf/route.C
  3. /etc/sysconfig/network-scripts/ifcfg-ethx
  4. /etc/sysconfig/network

Question 20

When using GAiA, it might be necessary to temporarily change the MAC address of the interface eth 0 to 00:0C:29:12:34:56. After restarting the network the old MAC address should be active. How do you configure this change? As expert user, issue these commands:

  1. Edit the file /etc/sysconfig/netconf.C and put the new MAC address in the field
  2. As expert user, issue the command:
  3. # IP link set eth0 addr 00:0C:29:12:34:56
  4. Open the WebUI, select Network > Connections > eth0. Place the new MAC address in the field Physical Address, and press Apply to save the settings.